Sig Sauer P226 Magblock 10/15 (9mm) (short follower)
This Magblock fits the Sig P226 15 round magazines and will limit them to 10 rounds. Easily installed in seconds at the base of the spring. It is held in place with spring tension alone or can be epoxied if desired.
- Simple install to make 10/15 Sig Sauer P226 magazines.
- No modification to the magazine is required.
- Lightweight and will not interfere with magazine reliability.
- Tested on factory Sig P226 magazines as shown in the photos. The block may need to be modified to work with magazines from other manufactures.
*This magazine is known to use two different types of followers depending on where they were manufactured. Please select the country of manufacture or your follower length below. The most accurate way is to measure your follower as shown in the photos.
Select your follower length or country of manufacture short follower (1 inch tall follower uses taller #11.5 block used in made in USA magazines